![]() ![]() button can be used to change the Z Height of the Composite 3D Model (the visible Components) if it is not an appropriate height for your material thickness.Ĭlicking this button will open the Set Model Height form which allows you to enter a new value for the overall height of the combined Components.Īfter you have entered a new value hit Apply and visually check the 3D model to ensure it still looks correct. This field simply reports the thickness of your composite model (as built from all your currently visible components). Gap Below ModelĪlternatively you can position your model by defining the gap between the bottom of the model and the bottom surface of the material. This distance positions your model according to the gap between the top of you model and the top surface of the material. You can also double left click on either of the three lines next to the slider to position the model at the top, center or bottom of the material. You can position your model within the material block wherever you wish by defining the gap distance either above or below your model. The thickness of your model must be less than the thickness of the material you wish to cut it from. If you are working in a 2 Sided environment the side you are setting up will be displayed in brackets e.g. This is a very important setting because the Tooling used on the CNC machine must be setup in the same way, ensuring the toolpaths cut to the correct depth. Select relative to the Material Surface or relative to the Machine Bed. This checkbox toggles the Material Setup summary layout on the Toolpaths tab between simple and detailed views. button to open the Material Setup form:Įnter the thickness of the material being machined. To access all these properties for editing, click on the Set. When you come to creating toolpaths, it is important to review this information and ensure it is still valid and also to set the machining clearances. Some of these values will have been initially set when the job was first created (see Job Setup for more information). The Material Setup section of the Toolpaths tab provides a summary of the current material settings. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |